Architecture Features (Hw); Electrical Characteristics; Environmental Specifications; Supported Hard Drive Technology - Intel SRCS14L - RAID Controller User Manual

2.3

Architecture Features (HW)

Table 5. Hardware Architecture
Component
I/O Microprocessor
Cache Memory
Flash Memory
I/O interface (PCI)
PCI Transfer Rate
PCI Signaling
SATA controllers
2.4

Electrical Characteristics

Table 6. Electrical Specifications
Voltage Requirements
Power Consumption
2.5

Environmental Specifications

Table 7. Environmental Test Results
Environmental Stress Test
Operating Temperature
Form Factor (physical dimensions)
2.6

Supported Hard Drive Technology

The RAID controller supports up to 4 hard disk drives connected to the 4 SATA ports. These hard
drives must be compliant with the SATA specification 1.0.
Technical Product Specification
The 80303 processor: 100MHz, RISC 64-bit core
3.3V unbuffered, PC100, ECC SDRAM. 64MB embedded not upgradeable
3.3v, 32Mb (4MB) flash memory chip is used to store the RAID firmware
PCI 2.2 compliant, universally keyed for 3.3 and 5 volt PCI slots
528 MB/sec (Burst) DMA to PCI and local buses
+5 or +3.3 volt
Two Silicon Image Sil3112A SATA controllers, which each control two serial
ports (four ports total) with speeds up to 1.5 Gbps
Attribute
Storage Temperature
Intel® Integrated RAID Controller SRCS14L
Features
Measurements
+3.3 or +5 Volts (all +/– 5% tolerance)
+5 Volts @ 0.25 Amps = 1.25W
+3.3 Volts @ 2.5 Amps = 8.25W
Meets Required Conditions
0° C to +55° C
-40° C to +70° C
Height: 56mm
Length: 167mm
13