To Set Freeform Tool Push/Pull Options - MACROMEDIA FREEHAND MX 11 Use Manual

To set Freeform tool Push/Pull options:

In the Tools panel, if the Freeform tool is not showing, select it from its pop-up menu.
1
Double-click the Freeform tool.
2
In the Freeform Tool dialog box, select Push/Pull.
3
Select the Push Settings options:
4
•
Set the pointer size in pixels by entering a value from 1 to 1000 in the Size box or by
adjusting the slider.
•
Set the tool precision by entering a value from 1 to 10 in the Precision box or by adjusting the
slider. Lower numbers mean lower precision and fewer points added to the path.
Select the Pull Settings options.
5
Select a Bend option from the pop-up menu:
6
specifies the length of the segment that will be affected, from 1 to 1000 pixels.
By Length
affects all of a path segment between its end points. A small s beside the pull
Between Points
pointer shows when this option is active.
If you are using a pressure-sensitive drawing tablet, set the Pressure options:
7
activates the tablet's pressure-sensitive size adjustment capability.
Size
activates the tablet's pressure-sensitive length adjustment capability.
Length
Click OK.
8
Drawing 91