Installing And Starting Fireworks - MACROMEDIA FIREWORKS 2-USING FIREWORKS Use Manual

Installing and starting
Fireworks
Before installing Fireworks, make sure your computer
meets the system requirements listed in "System
requirements" on page 10. Read the ReadMe document
on the Fireworks CD-ROM for late-breaking
information.
To install and start Fireworks on Windows NT 4 or
Windows 95 or 98:
Insert the Fireworks CD-ROM in your CD-ROM
1
drive.
Follow the instructions that appear on screen.
2
The installer application prompts you to enter
required information.
When Fireworks is installed, launch Fireworks
3
from the Start menu.
Windows NT 4 and Windows 95 or 98 have four
alternative ways to install Fireworks:
Double-click the installation application Setup.exe.
Click the Install button in the Add/Remove
Programs module in the Control Panel and
navigate to the Setup.exe application in the
Fireworks folder.
Use the Run command in the Start menu and
navigate to the Setup.exe application in the
Fireworks folder.
Select the CD-ROM icon in the Windows
Explorer or My Computer, right-click to display the
menu, and choose AutoPlay.
Note: To disable AutoPlay, hold down the Shift key
while inserting the Fireworks CD-ROM.
To install and start Fireworks on a Macintosh:
Disable virus-protection extensions and restart
1
your computer.
Insert the Fireworks CD-ROM in your CD-
2
ROM drive.
Double-click to launch the Fireworks Installer.
3
Follow the instructions that appear on screen.
4
Double-click the Fireworks icon to launch
5
Fireworks from the Finder.
Getting Your Bearings 11