Table of Contents
Advertisement
Debugging Application Code from ColdFusion Studio
Specifying Server Mappings
The debugger relies on these mappings to communicate the correct file paths of all
files with breakpoints to the ColdFusion server. See
45
for a full discussion.
You create these mappings in the Mappings pane of the Remote Development Settings
dialog box.
To specify server and file mappings for debugging:
1. Select Debug > Development Mappings to open the Mappings pane of the Remote
Development Settings dialog box.
2. In the ColdFusion Server list box at the top of the dialog box, choose the
ColdFusion server against which you'll run the debugging session.
3. In the Studio Path box, enter the file path ColdFusion Studio uses for the page
you're debugging. Click Add.
If you're debugging against a local server, the Studio and ColdFusion Server paths
are the same. So if you chose localhost, for example, in the ColdFusion Server list
box above, the CF Server Path is the same as the Studio path you just entered.
4. If you're debugging against a remote server, enter the CF Server Path.
The CF Server path needs to be the same as the alias or virtual mapping your web
server uses to access the file.
5. Specify the Browser Path, or URL, of the application and click Add.
6. Click OK.
"Adding Server Mappings" on page
85
Advertisement
Table of Contents
