Table of Contents
Advertisement
Before You Begin the Installation
Before You Begin the Installation
This section contains the following pre-installation instructions:
Required operating system settings
The following list includes patches that must be installed, kernel settings that must
be configured, and general issues to consider before installing ColdFusion Server 5:
Upgrading from a previous version
The ColdFusion Server installation automatically upgrades previous versions of
ColdFusion Server for HP-UX 11.0.
However, to continue to use VisiBroker for CORBA connections in ColdFusion Server
5, copy the libraries bundled with ColdFusion Server 4.5.1 into the appropriate
directory. If you uninstall a previous release of ColdFusion Server before installing
ColdFusion Server 5, these libraries are removed from your system. Before the
uninstall, copy the libraries to a safe location.
Required operating system settings
Upgrading from a previous version
Verifying that a Web server is running
Mounting the installation CD-ROM
Uninstalling ColdFusion Server 5
Ensure that you have the latest HP-UX 11.0 patch bundle installed. To download
the latest patch bundle, go to http://www.hp.com.
Configure your minimum kernel parameter settings as follows:
maxdsize
maxssize
maxtsize
maxfiles
maxusers
max_thread_proc
Note the Web server, Web root, and configuration file locations. They will be
needed during the installation.
Note the HP-UX username under which ColdFusion Server will run. It will be
needed during the installation.
Note where you want to install ColdFusion Server on your system (/opt is the
default directory).
0x79000000
0x8000000
0x8000000
1024
64 (to indirectly boost NKTHREAD, used below)
(NKTHREAD-10)
57
Advertisement
Table of Contents
Need help?
Do you have a question about the COLDFUSION 5 - INSTALING AND CONFIGURING SERVER and is the answer not in the manual?