Assigning Door Station Labels; Viewing System Information; Restoring Factory Settings - Russound COMPOINT SYSTEM Instruction Manual

Assigning door station labels

To assign labels to the door stations, follow
these steps (or the ISK2 Keypad Door Name
Procedure flow chart on page 26):
1. Press and release the Setup button on the right
edge of the keypad to enter the main menu. The
display shows ZName (ZONE NAME).
2. Press and release the Next key once. The display
shows DName (DOOR NAME).
3. Press the Talk key to enter the Door Name proce-
dure. The display shows Dr#? to prompt you to
select a door station number.
4. Press the Volume Up or Volume Down key to
select a door station.
5. Press and release the Talk key. The display shows
Name? to prompt you for a door station label.
6. Use the Volume Up or Volume Down key to select
a label from the list of door station labels. You can
press and hold the key to scroll through the list of
zone labels with a half-second delay between
items. Stop at the desired label.
7. Press and release the Talk key to save the selec-
tion. The display shows Dr#? to prompt you to
select the other door station.
8. To assign a label to the other door station, repeat
steps 4 through 7.
Press and release the Setup button once to exit
the procedure or twice to exit the main menu.
Once you have assigned the hub ID numbers
(for systems with multiple hubs), doorbell
chimes, zone labels, and door station labels,
the system is fully programmed.

Viewing system information

The System Info Menu allows you to check the
build time, build date, and version of the hub's
firmware. This is useful to see whether the hub
has the latest firmware version. To view system
information, follow these steps (or the System
Info Menu flow chart on page 27):
1. Press and release the Setup button on the right
edge of the keypad to enter the main menu. The
display shows ZName (ZONE NAME).
INSTALLER SECTION
2. Press and release the Next or Previous key twice.
They display shows SInfo (SYSTEM INFO).
3. Press the Talk key to enter the System Info menu.
The display shows BTime (BUILD TIME).
4. Press and release the Talk key to view the build
time, or
5. Press the Next key to go to BDate (BUILD
DATE).
6. Press and release the Talk key to view the build
date, or
7. Press the Next key to go to Ver (VERSION).
8. Press and release the Talk key to view the version.
Press and release the Setup button once to exit
the procedure or twice to exit the main menu.

Restoring factory settings

The Factory Initialization Procedure resets the
zone and door station label assignments and
zone volume settings to the original factory
defaults. This procedure affects the hub to
which the keypad is connected, and initializing
hub 1 also resets the entire system.
To restore the factory settings, follow these
steps (or the Factory Initialization Procedure
flow chart on page 27):
1. Press and release the Setup button on the right
edge of the keypad to enter the main menu. The
display shows ZName (ZONE NAME).
2. Press and release the Next key three times or the
Previous key once. The display shows FInit
(FACTORY INIT).
3. Press the Talk key to enter the Factory Initialization
Procedure. The display shows Sure? (ARE YOU
SURE?).
4. Press the Volume Up or Volume Down key to
select Yes.
5. Press the Talk key to initialize the system. The dis-
play shows Please Wait, followed by Cycle
Power.
6. Cycle the power on the hub to which the keypad is
connected.
Programming
25