Table of Contents
Advertisement
Device installation and trim
The ISH1 hub is designed for surface mounting
or installation in a structured wiring panel. It
should be located near an electrical outlet.
The ISK1 and ISK2 Keypads are designed to
install in standard US electrical plastic wall
boxes with an internal volume of at least 18
cubic inches (295 cm
a single gang and accepts a Decora
For the best accessibility, viewability, and micro-
phone reception, we recommend installing the
keypads at a standard thermostat height of 58
to 60 inches (1.5 m). This may vary according
to personal preferences or requirements.
The ISK3 Door Station installs in a standard sin-
gle-gang US electrical deep plastic wall box with
an internal volume of at least 22 cubic inches
3
(360 cm
). It has its own weather-resistant front
plate and thus needs no other cover plate.
The ISDR1 Door Strike Release Module is a sur-
face-mount device. It should be located in an
accessible area near the door, such as an attic,
basement, or closet space between the door
station and the hub. The ISDR1 connects to a
door strike release unit, which in most cases
would be installed by a security contractor.
Wiring and connections
ComPoint system components connect with
CAT-5 cable. Run CAT-5 from the hub location to
every keypad and door station location. If you
are installing ISDR1 modules, loop the door sta-
tion cables through the module locations.
Each keypad in the system requires one or two
external speakers. If the ComPoint system is
sharing speakers with an audio system, loop
the speaker cables through the keypad loca-
tions. If dedicated speakers are being used, run
the speaker cables to the keypads.
3
). Each keypad occupies
®
wall plate.
INSTALLER SECTION
When running CAT-5 and speaker cables, avoid
running them near AC power wiring. If you must
run the cables parallel to electrical wiring,
space the cables at least 12 inches (30 cm)
from the AC power lines.
110 punch-down connections
The keypads, door stations, and door strike
release modules have 110 punch-down connec-
tors for the CAT-5 cables. Connect the wires
with a punch-down tool as shown below.
BR BR/W G G/W O O/W BL BL/W
110 punch-down connection
The keypad wire functions are as follows:
Wire Color
Brown
Brown/White
Green
Green/White
Orange
Orange/White
Blue
Blue/White
Installation
BR BR/W G G/W O O/W BL BL/W
Function
Audio +
Audio –
Status
Ground
Ground
+ 15 VDC
Com A
Com B
19
Hide quick links:
Advertisement
Table of Contents
