Brush Speed Selector; Brush Indicator; Automatic Shut Off - Hoover F5858910 Owner's Manual

With clean surge the easy to use carpet cleaner with attached tools
Hide thumbs Also See for F5858910:
Table of Contents

Advertisement

Available languages

Available languages

2-5
E
Automatic "shut off"
When the recovery tank (lower tank) is
full the automatic shutoff mechanism
will shut off the carpet cleaner suction
(suction will be noticeably reduced).
At that time the yellow float disk will
rise to the top of the recovery tank
lid (E). The carpet cleaner will no
longer pick up dirty solution and the
motor sound will become notice-
ably higher in pitch.
When this happens turn carpet
cleaner off and empty recovery
tank before continuing use.
Check clean solution tank also; it
may need to be refilled.
2-8
H
To clean screen (H), turn carpet clean-
er off and disconnect from electrical
outlet.
Remove clear cover and wipe off
screen with a damp cloth. Snap
cover back into position.
8
2-6

Brush speed selector

Your SteamVac™ carpet cleaner has
three agitator brush settings.
Hl - for normal cleaning of carpet
and bare floors
LO - for gentle cleaning of carpets
and bare floors
OFF - for cleaning carpets and bare
floors when brushing is not desired.
(Such as when picking up liquid
spills. See page 11.)
Slide selector button to the desired
setting before cleaning.
2-9
The tanks
Clean solution tank
(upper tank)
The clean solution tank holds the
cleaning solution that is to be dis-
persed onto the surface to be
cleaned.
How to fill
Disconnect carpet cleaner from
electrical outlet.
Place carpet cleaner handle in the
upright, locked position.
To remove tank, press down on han-
dle and pull forward.
2-7
F
G

Brush indicator

The brush indicator will spin (F)
when the carpet cleaner is turned
ON and the brushes are rotating.
If the indicator does not spin and
the pattern is visible (G) when the
carpet cleaner is turned ON, the
brushes are not rotating.
There are three reasons why the
brushes may not be rotating:
1. Brush speed selector set on OFF
(see previous section).
2. Solution tube connected (Fig.
3-10).
3. Brush indicator screen dirty (Fig.
2-8).
2-10
Carry tank to a sink.
Rotate tank cap counterclockwise
and lift up to remove cap.

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents