Advertisement
10
12
15
502020.75.24_021V4D0101_1010_IM_bernette 10 12 15_EN_DE_NL_FR
Walking foot
EN
Presser foot available as optional accessory.
Always try to sew first without the walking
foot accessory which should be used only
when necessary.
The "Walking foot" accessory equalizes the
feeding of the upper and lower layers of fabric
and improves the matching of plaids, stripes
and patterns. This foot helps to prevent uneven
feeding of very difficult fabrics.
1. Lift the presser foot bar.
2. Remove the "presser foot holder". (see page
26)
3. Attach the "walking foot" to the machine in
the following way.
i) The fork arm should fit into the needle
screw and clamp. (2)
ii) Slide the plastic "attaching head" from
your left to right so that it is fitted on
the "presser foot bar".
iii) Lower the "presser foot bar".
iv) Tighten the fixation screw
4. Make sure both the "needle screw" and the
"fixation screw" are tight.
5. Draw the bobbin thread up. Lay both
threads to the back under the foot.
a Fork arm
b Attaching head
c Needle bar
d Needle screw & clamp
e Presser bar attaching screw
f
Presser foot bar
Advertisement
