Needle Threader; Bringing Up The Lower Thread; Thread Cutter; Changing The Needle - Bernina Artista 730E Instruction Manual

Needle Threader

Thread in Hook
lower the presser foot
lay the thread behind
hook B and hold
lightly

Bringing up the Lower Thread

Thread Cutter

Changing the Needle

!
Refer to the safety instructions!
A
B
Lever Down
press lever A down
and simultaneously
guide the thread
around hook B to the
right to the needle
if bobbin thread is cut on the cutter (page 13), there is no need to bring the
•
thread to the top of the stitch plate
hold the upper thread
sew one stitch:
normal sewing with presser foot down
•
by tapping on foot control with your heel, with presser foot up
•
pull the upper thread to bring the lower thread up through the stitch plate hole
take both threads through the slit on the presser foot to the back
pull threads over the head frame cutter
Thread Cutter on Head Frame
pull both threads from front to back over the cutter
the threads release as soon as the first stitch is sewn
•
Note:
The bobbin thread must be brought up through the stitch plate for
certain types of work. The length of thread is sufficient for most
normal work if the lower thread cutter has been used.
Thread in Front of
Needle
put the thread from
the front into the
guide until it catches
in the hook
Removing the Needle
raise the needle
turn power switch to «0» (off)
lower the presser foot
loosen the needle clamp screw
pull the needle down to remove
Inserting the Needle
loosen the needle clamp screw, if needed
flat side of needle to the back
insert the needle as far up as it will go
tighten the needle clamp screw
The Sewing Computer – Operating Instructions
Release the Lever and
Thread
let go of lever A and
thread
pull the thread loop
through the needle eye
15