Bernina Artista 730E Instruction Manual page 191

Messages
The authentication for the provider failed.
•
Please check the username and the password.
The communication with the provider was interrupted. Connecting problems occurred. Try to enter
•
Please try later or use another provider.
An unknown error occurred with the Modem.
•
Please try again.
You cannot save or delete files on
•
the myartista Portal.
A problem occurred in communicating
•
with the myartista Portal. Please try again.
To keep your sewing/embroidery computer
•
performing at its best, it's time to complete
the following tasks. Remove thread and lint from
beneath the stitch plate, as well as from the feed
dog area. These instructions can be found
on page 185 of the manual.
It's time for your regular service check.
•
Please contact your BERNINA dealer for
an appointment.
You have opted not to take your sewing/embroidery
•
computer to your BERNINA dealer for its service
check. This message will not appear until
it's time for the next regular service.
Please insert USB data stick that includes the
•
video-film tutorials and press «OK».
Main Motor failed. Please check hook system.
•
Notes
Check the settings in the Setup Program
and try again.
another provider if possible, or try again.
Remove modem, then reconnect.
The «myartista» portal provides tips and news.
Try to connect to the «myartista» portal again.
Remove and reconnect modem if necessary.
This notification will appear after approx.
180,000 stitches. After cleaning/oiling clear
the display by touching «OK». The display can
be cleared temporarily by touching «ESC»,
but will appear again when restarting the
sewing computer. After clearing with «ESC»
for the third time, the cleaning notification will
only appear again after a further approx.
180,000 stitches.
The sewing computer must be taken for a
service to a BERNINA dealer.
The notification will appear after approx.
2,000,000 stitches. If the service was done
bythe BERNINA dealer, the stitch counter will
be on «0» again and the display does not
appear anymore. The display can be cleared
temporarily by touching «ESC», but will appe-
ar again when restarting the sewing computer.
After clearing with «ESC» for the third time,
the notification will appear again at approx.
4,000,000 stitches.
Flawless functioning of the sewing/embroidery
computer can not be guaranteed if the
servicing is not carried out at the recommen-
ded regular intervals.
Connect the USB data stick to sewing/
embroidery computer that includes video-film
tutorials on various sewing techniques and
topics.
Open the bobbin cover. Remove any thread
lint from the hook area/bobbin case.
Sewing and Sewing Computer Support – Messages
189