Preparation
Securing Function (only Mode 2)
lower the feed dog
•
the presser foot pressure must be
•
reduced
use slide-on table
•
attach the desired presser foot sole
•
to the BSR presser foot
removing sole: press both buttons
•
(see arrows) on each side of the
foot
slide the sole down the groove at
•
an angle
attaching the sole: slide the sole up
•
in the groove until it clicks into
place
Using the following functions in the BSR mode:
Needle Stop Down (Default)
the arrow points down on the
•
display = the sewing computer
stops with needle down, when
taking foot off foot control
Needle Stop Up
press "Needlestop up/down" func-
•
tion. The arrow points up = the
sewing/embroidery computer stops
with the needle up on releasing
the foot control
Raise or Lower the Needle
by pressing the heel on the foot
•
control, the needle can be lowered
or raised
Securing With the Quick Reverse
Button (only Mode 1)
unplug the foot control
•
place the fabric under the presser
•
foot, lower presser foot
hold upper and lower thread tight
•
and press Quick Reverse button to
start BSR mode
sew 5 to 6 securing stitches
•
stop the BSR mode by pressing the
•
Quick Reverse button
cut threads
•
150
Quilt Stitches – Applications
re-start the BSR mode by pressing
•
the Quick Reverse button to conti-
nue the stitching process
Securing Function
(only Mode 2)
press the «Securing
•
Function» button
press the foot control or the Quick
•
Reverse button
short securing stitch sequence will
•
be sewn as soon as the fabric is
moved under the presser foot.
After the sequence is sewn the set
stitch length will be activated and
the securing function will be auto-
matically deactivated
Free Hand Quilting Without BSR
Activation
touch the BSR button (on the left
•
side on the display)
the BSR mode is deactivated, the
•
buttons «BSR1» and «BSR2» on
the left side on the display go off
normal free hand quilting can
•
now be sewn with the BSR
foot, without automatic regu-
lar stitch length
attach the BSR presser foot to the
•
sewing computer and plug the
cable into the green socket until it
clicks into place
the «BSR» screen opens automati-
•
cally
the BSR mode 1 is activated (BSR1
•
is standard)
the basic stitch length setting is
•
2mm
set the desired stitch length
•
when sewing small forms and
•
stippling, stitch length of 1mm -
1.5mm is suggested
When exceeding a
certain speed, adhe-
ring to regular
stitch length cannot
be guaranteed.
Make sure that the
lens on the bottom
of the BSR foot is
not dirty (finger-
prints, etc.). Clean
lens periodically
with soft, slightly
damp cloth.