Table of Contents
Advertisement
5.6
SCO Open Server 5.0.x
5.6.1 LSI
A. Building the SCO OpenServer BTLD Diskette
To create a BTLD diskette for SCO OpenServer system, copy the raw dd
image file onto a 1.44MB floppy disk. This process is dependent upon the
operating system that you are using to create this diskette. See the
instructions below for UNIX System and DOS System Users.
For UNIX System Users:
Follow these steps to create the BTLD diskette:
1.
Insert a 3.5" diskette into the floppy disk drive.
2.
At the UNIX prompt, type:
dd if=/<path>/sco.dd of=/dev/fd0135ds18
The <path> is where the dd image is located. On this CD-ROM, the dd
image file is located here:
\Drivers\Sdms\Drivers\UNIXES\OPNSERVR\SCO.DD
For DOS System Users:
Under this section, you have two choices.
1.
Use a utility that will copy the raw dd image onto a 1.44MB floppy
disk. This dd image is located at:
\Drivers\Sdms\Drivers\UNIXES\OPNSERVR\SCO.DD
RAWRITE3.COM, which is a public domain utility, is available on this
CD-ROM at this location:
\Drivers\Sdms\Drivers\UNIXES\RAWRITE3.COM
Instructions for using this utility are included in its accompanying
RaWrite file or as a Microsoft Word document located at:
\Drivers\Sdms\Drivers\UNIXES\RAWRITE3.DOC
2.
The other DOS alternative is to use the self-extracting image file that
is located at:
\Drivers\Sdms\Diskimag\OPNSERVR.EXE
5-30
®
SCSI Driver Installation
Chapter 5: OS Installation
Advertisement
Table of Contents
