Serial Ata - Gigabyte GS-R12T4H2 Service Manual

Serial ATA

Enabled Enables on-board serial ATA function. (Default setting)
Disabled Disables on-board serial ATA function.
Native Mode Operation
This option allows user to set the native mode for Serial ATA function.
Auto Auto detected. (Default setting)
Serial ATA Set Native mode to Serial ATA.
SATA Controller Mode Option
Compatible Mode
Enhanced Mode
Note: Pre-Win2000 operating system do not work in Enhanced mode.
SATA RAID Enable
Enabled
Disabled
SATA AHCI Enable
Enabled
Disabled
SATA Port 0/1/2/3/4/5
The category identifies the types of Serial SATA hard disk from drive 0 to 5 that has been
installed in the computer. System will automatically detect HDD type.
Note that the specifications of your drive must match with the drive table. The hard disk will not
work properly if you enter improper information for this category.
Hard drive information should be labled on the outside device casing. Enter the appropriate option
based on this information.
TYPE
1-39: Predefined types.
Users: Set parameters by User.
SATA and PATA drives are auto-detected and placed in
Legacy mode.
SATA and PATA drives are auto-detected and placed in
Native mode. (Default setting)
Enabled SATA RAID function.
Disable this function. (Default setting)
Set this item to enable SATA AHCI function for WinXP-SP1+IAA
driver supports AHCI mode.
Disabled this function. (Default setting)
6 3
BIOS Setup