Installing A Power Supply - Dell DR4000 Owner's Manual

Figure 3-11. Removing and Installing a Power Supply
1 power supply
3 velcro strap

Installing a Power Supply

1 Verify that both power supplies are of the same type and have the same
maximum output power.
2 Slide the new power supply into the chassis until the power supply is
fully seated and the release latch snaps into place. See Figure 3-11.
NOTE:
procedure, relatch it. For information about the cable management arm,
see the system's rack documentation.
3 Connect the power cable to the power supply and plug the cable into a
power outlet.
CAUTION:
When connecting the power cable, secure the cable with the Velcro
strap.
NOTE:
When installing, hot-swapping, or hot-adding a new power supply in a
system with two power supplies, allow several seconds for the system to recognize
the power supply and determine its status. The power-supply status indicator turns
green to signify that the power supply is functioning properly (see Figure 1-5).
If you unlatched the cable management arm in step 2 of the previous
4
2 power supply handle
4 release latch
Installing System Components
1
2
3
75