Table of Contents
Advertisement
11. Connect one end of the applicable signal cable into the rear of the drive and
12. Route the signal cable so that it does not block the airflow to the rear of the
13. If you have another drive to install or remove, do so now.
14. Connect the power cable to the rear of the drive. The connectors are keyed
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation" on page 62.
Installing an optional tape drive
To install an optional tape drive, complete the following steps.
make sure that the other end of this cable is connected into the applicable
SATA connector on the system board.
drives or over the microprocessor and dual inline memory modules (DIMMs).
and can be inserted only one way.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 29.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
3. Unlock the side cover.
4. Remove the side cover (see "Removing the side cover" on page 32).
5. Remove the two-piece bezel (see "Removing the two-piece bezel" on page
32).
6. Use a screwdriver to pry the filler panel and EMC shield away from the server.
7. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and
place it on a static-protective surface.
8. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
9. Remove the drive retainer clip from the side of the drive cage of bay 1 or 2.
Slide the drive retainer clip to the right to remove it from the drive cage; then,
snap the drive retainer clip into the screw holes on the side of the drive.
Chapter 2. Installing optional devices
43
Advertisement
Table of Contents
