Table of Contents
Advertisement
v The electromagnetic interference (EMI) integrity and cooling of the server are
v For a complete list of supported optional devices for the server, see
Installing a DVD drive
To install a DVD drive, complete the following steps:
protected by having all bays and PCI and PCI Express slots covered or
occupied. When you install a drive, PCI, or PCI Express adapter, save the EMC
shield and filler panel from the bay or PCI or PCI Express adapter slot cover in
the event that you later remove the device.
http://www.ibm.com/servers/eserver/serverproven/compat/us/.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 29.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
3. Unlock the side cover.
4. Remove the side cover (see "Removing the side cover" on page 32).
5. Remove the two-piece bezel (see "Removing the two-piece bezel" on page
32).
6. Use a screwdriver to pry the filler panel and EMC shield away from the server.
Note: If you are installing a drive that contains a laser, observe the following
safety precaution.
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices,
or transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product
could result in exposure to hazardous laser radiation. There are no
serviceable parts inside the device.
v Use of controls or adjustments or performance of procedures other
than those specified herein might result in hazardous radiation
exposure.
Chapter 2. Installing optional devices
41
Advertisement
Table of Contents
