This procedure applies only to server models that have hot-swap power supplies. If
the server contains a non-hot-swap power supply that requires replacement, the
power supply must be replaced by a service technician.
When you remove or install a hot-swap power supply, observe the following
precautions.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
To replace a hot-swap power supply, complete the following steps:
1. Review the safety information that begins on page vii and "Installation
guidelines" on page 29.
2. Disconnect the power cord from the power supply that is to be removed.
3. Press down on the orange release lever and pull the power supply out of the
bay, using the handle.
Release lever
Hot-swap power
supply
Chapter 2. Installing optional devices
59