Table of Contents
Advertisement
6.
After you have created the RAID 0 set, press any key to reboot the
system.
During POST, the FastTrak S150 TX4™ BIOS checks and displays the
disk array information.
7.
Once the array is created, use the FDISK utility to format the array as
a single hard drive.
8.
After you have formatted the arrayed drives, install an operating
system (OS). The OS will treat the RAID 0 array as a single drive unit.
During the OS installation, the system prompts you to install third-party
SCSI or RAID driver. Refer to section "2. RAID driver installation" for
details.
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
2 5
2 5
2 5
2 5
2 5
Advertisement
Table of Contents
