Table of Contents
Advertisement
1 . 6
1 . 6
1 . 6
FastBuild™ Utility
FastBuild™ Utility
FastBuild™ Utility
1 . 6
1 . 6
FastBuild™ Utility
FastBuild™ Utility
The FastBuild™ Utility allows you to create RAID 0, 1, and 0+1 set(s) from
SATA hard disk drives connected to the SATA connectors supported by the
Promise
®
PDC20319 RAID controller.
To enter the FastBuild™ Utility:
1.
Turn on the system after installing all the SATA hard disk drives.
2.
If this is the first time you restart the system with the new hard disk
drives installed and connected to the SATA connectors, the FastTrak
S150 TX4™ BIOS displays the following:
3.
Press <Ctrl+F> to display the FastBuild™ Utility main menu.
4.
To make sure that the SATA hard disk drives are properly installed,
press <2> to view the drive assignments. When finished, press <Esc>
to return to the main menu.
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
2 3
2 3
2 3
2 3
2 3
Advertisement
Table of Contents
