Table of Contents
Advertisement
1 . 5 . 6
1 . 5 . 6
Rebuilding a RAID set
Rebuilding a RAID set
1 . 5 . 6 Rebuilding a RAID set
1 . 5 . 6
1 . 5 . 6
Rebuilding a RAID set
Rebuilding a RAID set
The utility displays the condition of the RAID set during the POST. When a
RAID set is degraded, you can use the utility to rebuild it.
Check the physical connections of the SATA hard disk drives before you
rebuild a degraded RAID set. Check the system and motherboard user
guide for additional information.
To rebuild a RAID array:
1.
Enter the Adaptec RAID Configuration Utility following the instructions
in the section "Creating a RAID 0 (Stripe)."
2.
Select A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y from the initial menu, then
press <Enter>.
3.
From the main menu, highlight Manage Arrays, then press <Enter> to
display the installed RAID sets.
4.
Highlight the degraded RAID set, then press <Enter> to display the
array properties. The A r r a y S t a t u s
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n
A r r a y S t a t u s
A r r a y S t a t u s
A r r a y S t a t u s shows DEGRADED.
A r r a y S t a t u s
2 1
2 1
2 1
2 1
2 1
Advertisement
Table of Contents
