Table of Contents
Advertisement
Installing on the Wall
1. Remove the camera unit
See "Installing on the Ceiling" (see page 1).
2. Change the camera position
• Work with the locks on the sliding plate set
free.
1
Push the spring (A) and set free the hooks
from the base chassis. Lift and turn the
camera in the arrowed directions so that
the back of the camera becomes visible.
A
2
Rotate the camera so that the position of
the locks (B) is upside down.
B
3
Align the locks (B) with the slots (C) on
the base chassis, push the spring (A),
and mount the camera.
Keep the flat cable away from the chassis.
B
A
C
Do not adjust pan/tilt manually. They must be adjusted electrically.
3. Install the camera unit base
• Check the top and bottom of the camera unit
base using the pattern sheet.
1
Attach the cushioning sheet (D) to the
back of the camera unit base (E), open a
cable hole in the cushioning sheet, and
pass the cables through the cable hole.
2
Set the camera unit base (E) on the wall
so that its tightening screws (F) are
perfectly horizontal, then tighten them
securely with washers (4 places).
• Length: 35 mm or more
• Diameter: 3.5 to 5.0 mm
• Height of screw head: 5 mm or less
(washer included)
D
E
4. Mount the camera unit
1
Connect the cables from the wall.
Push the excess of connected cables into the wall.
For details on the connections, see page 5.
3
2
F
F
Advertisement
Table of Contents
