Step 3B: Configure The Controller For An Ethernet Connection; Figure 3-12 Port Settings Tab; Figure 3-13 Ip Configuration Tab - Honeywell HJK7000 Installation And User Manual

Step 3B: Configure the Controller for an Ethernet Connection

Document 800-02573 Rev B
11/2009
Figure 3-12 Port Settings Tab
To configure the controller for an ethernet connection:
1. From the side menu Settings:Hardware Config, click Port Settings. See
Figure 3-13.
2. In each of the fields, enter IP address, subnet mask, gateway and DNS values.
3. Click Apply to save the configuration, Cancel to exit without saving, or Default to
restore all factory default values.
Figure 3-13 IP Configuration Tab
UltraKey Plus Controller Installation and User Guide
53