Step 2: Configure Port Settings; Figure 2-5 Videoblox Serial Port Rs422 Connection Example - Honeywell HJK7000 Installation And User Manual

VB master:
1--RS422_TX –
2--RS422_TX +
3--RS422_RX +
4--RS422_RX –
5--GND
RJ45 define:
1--RS485_2+/RS422_2_TX+/
RS422_1_RX+
2--RS485_2-/RS422_2_TX-/
RS422_1_RX-
3—NC
4--RS232RX
5--RS232GND
6--RS232TX
7--RS485_1-/RS422_1_TX-
8--RS485_1+/RS422_1_TX+
*RS485_2/RS422_2_TX and
RS232 use same UART_AC

Step 2: Configure Port Settings

Document 800-02573 Rev B
11/2009
Figure 2-5 VideoBloX Serial Port RS422 Connection Example
VIdeoBlox Master
Connections
5
RJ45 to
DB9 Male
PI NOUT
5
RJ45
DB9
1
RJ45
Network
Cable
3
PSU
Controller 1
To configure port settings:
1. Apply AC power to the controller after all the devices have been connected correctly.
2. Press Alt + Clr + Home keys on the controller to display the Login page.
3. Enter the PIN password 3434.
The Settings screen displays.
4. If current mode is MAXPRO mode, change it to VB mode by pressing the Mode
Maxpro button and logging into the Settings menu again.
5. Press Hardware Config.
The current controller setting is displayed.
6. Press Port Settings and then COM1.
The Serial Setting menu displays where you can see these COM1 settings - serial port
mode, baud rate, databit, parity and stop bit.
7. Press Type to change the current type displayed on the screen. Select RS422.
8. Press Baudrate to select a baud rate: 1200 bps, 1800, 2400, 4800, 9600, 19200, or
57600.
UltraKey Plus Controller Installation and User Guide
VideoBloX Serial Port (RS422)
TX+ TX- GND RX-
#1 #2 #5 #7
#2 #1 #5 #4
5
RJ45 to
DB9 Male
RX+
#8
#3
1
RJ45
Network
Cable
3
PSU
Controller 32
33