Installing UltraKey Plus with MAXPRO-Net
Step 3A: Configure the Controller for a Serial Port Connection
52
Figure 3-11
MAXPRO Configuration Tab
To configure the controller for a serial port connection:
1.
From the side menu Settings:Hardware Config, click Port Settings. See
Figure
3-12.
2.
Under COM1 Settings, select the following from each drop down list as required:
•
Baud Rate: 1200, 1800, 2400, 4800, 9600, 19200 or 57600 bps
•
Parity: none, even, or odd
•
Stop Bits: 1 bit or 2 bits
•
Data Bits: 7 bits or 8 bits
•
Serial Mode: RS422
3.
If required, repeat
step 2
4.
Click Apply to save the configuration, Cancel to exit without saving, or Default to
restore all factory default values.
for COM2 Settings to select RS232.