Installing And Configuring An Ethernet Connection; Step 1: Connect To The Ultrakey Plus Ethernet Port; Step 2: Set And Configure For An Ethernet Connection; Figure 3-8 Ethernet Port Connections To Maxpro-Net - Honeywell HJK7000 Installation And User Manual

Installing UltraKey Plus with MAXPRO-Net

Installing and Configuring an Ethernet Connection

Step 1: Connect to the UltraKey Plus Ethernet Port

Step 2: Set and Configure for an Ethernet Connection

48
Table 3-2 RJ45 Ethernet Pin Assignments
Port Pin
RJ45 Ethernet 1
2
3
6
To connect to the UltraKey Plus Ethernet port:
1. Plug an RJ45 network cable from the network to the controller Ethernet port. Up to 99
controllers can be connected to the network. See
2. Connect MAXPRO-Net to the network. Refer to the applicable
Installation Guide for instructions.
Figure 3-8 Ethernet Port Connections to MAXPRO-Net
MAXPRO-Net
TCP/IP
To set and configure for an Ethernet connection:
1. Apply AC power to the controller after all the devices have been connected correctly.
2. Press Alt + Clr + Home keys on the controller to display the Login page.
3. Enter the PIN password 3434.
The Settings screen displays.
Signal
TX +
TX -
RX+
RX-
Figure
Ethernet Port
TCP/IP
RJ45 network cables
Network
TCP/IP
Ethernet Port
3-8.
MAXPRO-Net
Controller 1
Controller 32