Appendixes; Rear Panel's Input/Output - JVC SR-L910UA - 24 Hour Time Lapse Vcr Instructions Manual

11 APPENDIXES

11-1 Rear Panel's Input/Output

[CAM SW OUT] camera switching signal output
The CAM SW OUT terminal outputs a camera switching timing signal to the connected sequential switcher. The switching interval
can be set with the <CAMERA SW> on the VTR mode 1 setting screen. The camera switching signal is output at ground level.
Camera
switching
During recording
signal output
timing
During standby
With the <CAMERA
SW> function menu
switch set to "1
FIELD"
Other input/output terminal signal levels
Terminals
ALARM IN
Alarm signal input
ALARM RST IN
Alarm signal reset
input
ALARM REC OUT
Alarm recording
mode signal output
TAPE END OUT
Tape end signal
output
WARNING/REC
OUT
Warning signal/Rec
mode signal output
CLOCK RESET IN
Clock reset input
CLOCK RESET
OUT
Clock reset output
54
1 field
Time
GND
Signal levels
Record mode:
repeat recording ON/auto rewind ON
LV: 0 V
Max. 10 mA
About 2
seconds
Warning
5m sec
LV: 0 V
Min. 400 ms
HV: 5 V ~ 12 V
Min. 400 ms
HV:12 V
(output impedance: 4.7 kohms)
Alarm
Record mode
Record mode:
repeat recording OFF/auto rewind OFF
Tape end
HV: 12 V
(output impedance: 4.7 kohms)
Warning reset
LV: 0 V
Min. 150 ms
LV: 0 V
About 150 ms
Timelapse recording
Camera switching signal
(open-collector output)
Remarks
Input at ground level
Input at high level
Output at high level
Output at ground level
Manual
operation
Output at high level
Input at ground level
Output at ground level