JVC SR-L910UA - 24 Hour Time Lapse Vcr Instructions Manual page 22

5 SETTING OF THE FUNCTION MENU SWITCHES
5-2 Contents of the Function Menu Switches
[ ]: Factory setting
Screens Items
Alarm/sensor ALARM REC
recording mode
setting
SENSOR REC
REC MODE
DURATION
BUZZER
TAPE END
MODE
RS-232C
This screen is displayed on the on-screen setting screen only when the (optional) RS-232C board
parameter
SA-K97U is installed.
setting
BAUD RATE
22
Set values
[OFF] Turns the alarm recording function on or off.
ON Alarm recording is enabled only in the Timelapse Record mode.
An index code (VISS signal) is also recorded at the start point of alarm
recording as an alarm cue signal.
OFF : Alarm recording is disabled.
ON : This unit enters the Record mode (VHS SP or VHS EP mode) set with
the menu switch<REC MODE>, when an alarm signal is input to the rear
panel's [ALARM IN] terminal during timelapse recording.
[OFF] Turns the sensor recording function on or off. Sensor recording is enabled in
the Stop mode. An index code (VISS signal) is also recorded at the start point of
ON
sensor recording.
OFF : Sensor recording is disabled.
ON : When an alarm signal is input to the rear panel's [ALARM IN] terminal in
the Stop mode. this unit automatically starts recording in the Record
mode (VHS SP or VHS EP mode) set with the menu switch <REC
MODE>.
[2H] Selects the recording mode for alarm recording or sensor recording.
2H : Recording is executed in the VHS Standard (SP) mode.
6H
6H : Recording is executed in the VHS EP mode.
5 Selects the recording duration for alarm recording or sensor recording.
15 5 ..... 180 : Alarm or sensor recording is performed for the time specified (5 sec.
30
60 TAPE END: Alarm or sensor recording continues until the tape ends.
120
MANUAL : Alarm or sensor recording continues for as long as alarm signals
[180]
TAPE END
MANUAL
[OFF] Selects whether or not the alarm buzzer sounds during alarm or sensor
ON recording.
OFF : The buzzer does not sound.
ON : The buzzer sounds.
[STOP] Set the operation mode at tape end during recording in the case when alarm or
REW
sensor recording is executed even once.
REPEAT
STOP
EJECT
REW
REPEAT : Rewinds the tape automatically to the beginning and restarts
EJECT
Select the RS-232C data transfer speed from 1200 bps, 2400 bps, 4800 bps or
1200
9600 bps.
2400
4800
[9600]
Function
to 180 sec.).
are input.
Set to this position when specifying the alarm recording time with a
switcher.
: Stops at tape end.
: Rewinds the tape automatically and stops.
recording.
: The tape is ejected.