Noise Or Static - Uniden UDW10055 User Manual

Signal Level Icon
Fair
Low
Zero
If the suggestions above don't provide enough improvement in the the signal quality, you may
want to run the camera at QVGA or zoom mode. When the camera is in zoom mode, it sends fewer
pixels to the receiver, so the video performance is not as affected by the weak signal.

Noise or Static

The most likely cause of noise (flickering image) or static is interference. There are many common
sources of interference:
electrical appliances, especially microwave ovens
►
computer equipment, especially wireless LAN equipment
►
other radio-based wireless devices, such as cordless telephones
►
wireless controllers, or wireless headphones or speakers
►
large florescent light fixtures (especially if they give off a buzzing noise)
►
working motors (hair dryers, heater/air conditioners, water pumps)
►
20
Data Rate (kbps)
543~725
250~543
0~250
Frames per second (approx)
QVGA (Zoom)
8~12
0~5
0
VGA (Normal)
2~4
0~1
0