Using The Menu - Uniden UDW10055 User Manual

Using the Menu

To open the menu,
press
Use
and
DOWN
to move
the cursor
Item
Audio Vol
Scan Time
CAM1 – CAM4
Pair CAM
System Setup sub-menu
Brightness
TV out
Power Save
Factory Reset
OK
Audio Vol
Scan Time
CAM1
UP
CAM2
CAM3
CAM4
Pair CAM
System
Factory
Use it to
Adjust the volume of the audio from the camera. Choose a value from 0 (off)
through 20 (maximum).
Set the length of time the receiver spends on each active camera during a scan
(see page 16) or activate quad display (see page 17).
Turn each of the four camera channels On (enabled) or Off (disabled).
Pair a camera to the selected channel (see page 14).
Adjust the brightness of the display. Choose a value from 1 (min) through 15
(max).
Change the video output format from NTSC (North America) to PAL (Europe).
Turn on power save mode. If you set this field to Auto, the display turns off if it's
idle for more than one minute. (The audio will remain active.) To turn the display
back on, press .
ok
Reset the receiver to factory defaults. Any changes or settings will be lost.
The selected
item is
highlighted
9
10
through the
OFF
ON
ON
ON
ON
1 2 3 4
Setup
To open the
System Setup
Reset
sub-menu, press
To close the menu, press
Use
LEFT
and
RIGHT
to scroll
11
options for
the item
Brightness 10
TV out NTSC
Power Save OFF
OK
OK
11