Related Manuals for Reflex RSC
Summarization of Contents
Safety
Explanation of Symbols
Explains symbols and signal words used in the manual.
Personnel Requirements
Specifies qualified personnel for installation and maintenance.
Personal Protective Equipment
Details required personal protective equipment (PPE).
Intended Use
Describes the device's intended purpose in heating/cooling systems.
Inadmissible Operating Conditions
Lists applications where the device should not be used.
Residual Risks
Highlights potential residual risks like burns and injuries.
Device Description
Description and Overview
Provides an overview and visual diagram of the device components.
Identification and Type Codes
Details information found on the device's nameplate and type codes.
Device Functionality
Explains the functional principles of the device.
Technical Data
Control Unit Specifications
Technical specifications for the control unit.
Vessel Specifications
Technical specifications for the primary vessel.
Optional Equipment and Accessories
Details available optional equipment and accessories.
Installation Guide
Installation Conditions
Requirements for installing the device.
Incoming Inspection
Procedure for checking the device upon receipt.
Preparatory Work
Steps to prepare the device and installation site.
Execution - Locating the Vessel
Steps for physical installation and placing the primary vessel.
Installation Connections
Facility System Connections
Guides for water-side and control unit connections.
Make-up and Degassing Variants
Explains the make-up and degassing functionality.
Electrical Connections and Make-up
Electrical Connection Details
Details on electrical connections, terminal diagrams.
Make-up Variants
Describes make-up without pump, with pump, and with softening/degassing.
Commissioning Requirements
RS-485 Interface
Details the RS-485 interface for communication.
Pre-Commissioning Checks
Verifies prerequisites before initial commissioning.
Commissioning Settings
Reflexomat Switching Points
Explains the device's switching points and pressure settings.
Controller Start Routine
Guides on adjusting the controller's initial setup routine.
Commissioning and Operation Modes
Vessel Venting and Filling
Instructions for venting and filling the primary vessel with water.
Starting Automatic Mode
How to start the automatic operating mode.
Operating Modes Overview
Overview of the different operating modes: Automatic, Manual, Stop.
Controller Interface and Configuration
Operator Panel Overview
Description of the controller's operator panel and buttons.
Configuring Controller Settings
How to adjust controller settings for system conditions.
Controller Settings and Messages
Default Settings
Lists the default settings for the controller.
Understanding Controller Messages
Explains the various messages and error codes displayed by the controller.
Controller Message Details
Message List and Causes
Explains the various messages and error codes displayed by the controller.
Maintenance Schedule
Regular Maintenance Tasks
Provides a schedule for regular maintenance tasks.
Maintenance Procedures
Checking Switching Points
How to check and verify the device's switching points.
Cleaning the Vessel
Step-by-step guide to cleaning the primary vessel.
Maintenance and Inspection
Cleaning the Dirt Trap
Instructions for cleaning the dirt trap.
Inspection Guidelines
Guidelines for inspecting pressure-bearing components and intervals.
Disassembly Instructions
Steps for safely disassembling the device.
Annex Information
Customer Service Contact
Contact details for customer service.
Conformity and Guarantee
Information on device conformity, standards, and guarantee.
Need help?
Do you have a question about the RSC and is the answer not in the manual?
Questions and answers