Setting The Signal Format; Connecting Monitor And Power - Honeywell HCU484 User Manual

Setting the Signal Format

Figure 3
Set signal format
Set the signal format switch (see
NTSC for North America
PAL for International

Connecting Monitor and Power

Note Check the power source from the external
power supply before applying power to the
camera.
1. Connect the VIDEO connector on the rear of the camera
to the video-in connector on your monitor.
2. Connect the camera to a 12 VDC or 24 VAC power supply
(appropriate to your installation). Use a screwdriver to first
loosen the ~AC24V/DC12V terminal screws on the
terminal block.
Figure 4
Note To ease installation, the terminal block can be
removed. The power connections of the
removable terminal block are not polarity-
sensitive. Connect either power lead to either
connector terminal.
3. Secure the power leads by retightening the terminal
screws until snug.
Rev 1.01
Camera Rear View
Figure
Video Connections
Power LED
NTSC PAL
LENS
VIDEO
3
3) to:
ENTER
12VDC
24 VAC
+ -
-
+
RX RX
Document 900.0418
10/06