Table of Contents
Advertisement
Installation
Installing the Lens
Note
You must use an Auto Iris lens to take full
advantage of this camera's wide dynamic
performance.
Note
The camera auto senses whether an Auto Iris
lens or a Manual Iris lens is attached.
The HCU484 Series camera is factory configured for a CS-
mount lens.
Follow
Figure 1
!
lens
into the front of the camera body
Figure 1
!
Figure 2
Pin DC Lens
1
2
3
4
Adjusting the Flange Back Focus
The back focus adjustment is accessible at the front end of the
camera housing to adjust the back focal length or picture
focus.
1.
Loosen the setscrews with a Phillips screwdriver.
2.
Adjust the focus ring to focus the picture.
3.
Retighten the setscrew.
Rev 1.01
to attach a customer supplied lens, screw the
CS Mount
Setscrew
Pin Definitions
CTRL -
CTRL +
DRV +
DRV -
"
.
"
1
3
2
4
2
Document 900.0418
10/06
Advertisement
Table of Contents
