ROSE DISPLAYS SUPERSNAP WITH ANOCONNECTORS, CABLE CLIP, AND BALL CHAIN Manual

SuperSnap™ with AnoConnector
Parts
CableClip
06-5050
Instructions for assembly
Step 1
Insert single ball of ball chain into inner
channel of Cable Clip. The cable should
snap into place. Fig. 1
Align one round end of cable clip with top
channel of the rail and insert. Once in
place, insert end of ball chain into channel.
Then press down on the other round end of
the cable clip and slide into rail by pushing
on the clip. Fig. 2
Note: Be sure to push on the cable clip in
order to slide the ball chain into place. Do
not pull on, or push against, the ball chain
as this will cause it to bind in the channel.
Note: Position CableClip about halfway
down each SuperSnap. Fig. 3
Step 2
Insert AnoConnector into rail of one
SuperSnap. Make sure tabs face upward. The
side with one tab must go in first. Fig. 4
Step 3
Insert threaded rod halfway into clip rail of
the same SuperSnap. Fig. 5
Step 4
Push the second piece of SuperSnap onto
both AnoConnector and the threaded rod.
Push together until
both holders meet. Fig. 6 Repeat steps 2-4
for additional SuperSnaps.
The SuperSnap™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSSuperSnapAnoConnectorCCBC
Incept-11.13.02
SuperSnap End Caps
12S300 06-5475
6" Rod
97-0304-06
AnoConnector
06-2930
Figure 1
Figure 3
Figure 5
Instruction Sheet
Ball Chains
96-0302P
Figure 2
Figure 4
Figure 6
Page 1 of 2
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com