ROSE DISPLAYS ANOGOTCHA ROUND WITH CABLE CLIP AND BALL CHAIN Manual

AnoGotcha™

Parts

Ball Chains
96-0302P

Instructions for Hanging

Step 1

Insert T-Top Gotcha Holder into AnoGotcha
Shell. Fig. 1

Step 2

Insert single ball of ball chain into inner
channel of Cable Clip. The cable should snap
into place. Fig. 2
Note: For OneUp Application place
the Cable Clip in the center of the
AnoGotcha Holder.

Step 3

Align one round end of cable clip with top
channel of the aluminum rail and insert.
Once in place, insert end of ball chain into
channel. Then press down on the other
round end of the cable clip and slide into rail
by pushing on the clip. Fig. 4
Note: Be sure to slide the ball chain into
place by pushing on the cable clip. Do not
pull on, or push against, the ball chain as
this will cause it to bind in the channel.

Step 4

Push end caps into place. Fig. 4

Step 5

Snap the AnoGotcha Holder open and insert
poster (top and bottom). To close, snap the
AnoGotcha Holder shut. Fig. 5

Step 6

Suspend poster. Fig. 6
AnoQuick™ and AnoGotcha
trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales
agent may be held liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoGotchaCableClipBallChain
Incept-7.4.02
OneUp Instruction Sheet
AnoGotcha Shell
12AG400
™ ®
are trademarks and Gotcha is a registered
T-Top Gotcha
12GT100
Figure 1
Figure 3
Figure 5
Cable Clips End Caps
06-5050
Figure 2
Figure 4
Figure 6
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
06-5525