Selecting Telephone Mode / Entering A Number / Switching Off The Microphone; Receiving / Ending A Call - PEUGEOT 607 Manual

Selecting telephone mode / Entering a number / Switching off the microphone

To change to telephone mode, press the 'TEL' button or for more than 2 seconds on the steering column
remote control.
Insert your SIM card fully into the slot at the front (use only the new generation 3V SIM card with bank card
format).
Note: the SIM card must not be taken out while the audio/telephone system is still in use. If you forget to do this, an audible
signal will sound for a few seconds after the ignition is switched off.
Enter your PIN number and confirm with the 'OK' button in order to access the network. The welcome screen is
displayed.
Note: the PIN code is erased each time the ignition is switched off, but the ''PIN code protection'' function may be
cancelled.
Enter the number of the person you wish to speak to on the digital keypad and pres the 'OK' button to make the call.
To switch off the microphone mid-communication, press the 'TEL' button.
Cancelling the PIN code request
To cancel the PIN code request, select 'PIN code protection' in the 'Telephone parameters' menu and confirm; select 'OFF'
and confirm, then input your PIN code and confirm.

Receiving / Ending a call

When a ringing sounds to let you know that a call is waiting, you can choose either to accept it by press-
ing the 'OK' button or not to accept it by pressing button P or by selecting 'Refuse call' using the steer-
ing column remote control, pressing the end to confirm.
If you do not accept it, the call is diverted to your voice mail (if this service is available and active).
To end the call, press button P or the end of the steering wheel remote control.
Note: Not accepting or ending a call by means of the steering wheel control returns the system to radio mode.
Receiving two incoming calls
During a call, when there is another incoming call, you are informed of this by a ring and a message. You may choose:
– to accept the call by pressing button 2 then "OK"; the first caller is put on hold and you are in contact with the second.
However, pressing button 2 again allows you to return to the first caller,
– to finish the call you are on and talk to the second caller by pressing button 1 then "OK",
– not to accept the new call by pressing button "C".
15-07-2002
YOUR 607 IN DETAIL
63