Automatic Switching On Of The Lights; Operating Check; Neutralisation - PEUGEOT 607 Manual

110
Automatic switching
on of the lights
Side lights and dipped beam head-
lamps switch on automatically if the
light is poor, or during continuous
operation of the windscreen wipers.
They switch off as soon as the light
becomes bright enough or the wind-
screen wipers stop.
Note : in foggy weather, the bright-
ness sensor can detect sufficient
light. As a consequence, the lights
will not come on automatically.
This function is active when the vehi-
cle is supplied to the customer.
To switch the function on or off:
Place the key in the accessories
position (1st notch),
Change the stalk position to 0,
Press the end of the stalk for more
than two seconds.
Note : after the ignition is switched
off and depending on the brightness,
the lights remain on for approximate-
ly thirty seconds or until the vehicle is
locked.
15-07-2002
YOUR 607 IN DETAIL
Do not cover the sunshine /
brightness sensor located in the
centre of the fascia. It helps to
regulate the air conditioning,
automatic switching on of the
lights and the automatic adjust-
ment of the instrument panel
brightnes.

Operating check

Activation
When this function is acti-
vated, the indicator light
comes on, accompanied by
an audible signal.
The light also comes on as soon as
the driver changes the stalk position
to 0.

Neutralisation

When neutralising the func-
tion, the indicator
comes on, accompanied by
an audible signal.
The indicator light also comes on as
soon as the driver uses the manual
lighting controls.
If the sunshine / brightness sen-
sor does not function correctly,
the system activates the function
(the lights come on) and the dipped
beam headlamps indicator light on
the instrument panel flashes.
Contact a PEUGEOT dealer to have
the system checked.
light