Windscreen Wiper Stalk; Maintenance Position; Windscreen And Headlamp Wash; Screenwash/Headlamp Wash Low - PEUGEOT 607 Manual

WINDSCREEN
WIPER STALK
Windscreen wipers
3 Fast wipe
2 Normal wipe
1 Automatic wipe
0 Off
When the ignition has
switched off for more than a
minute with the control in a wipe
position (1, 2 or 3), it is necesary
to reactivate this function. To do
this, move the stalk to any position,
then move it back to the required
position.
15-07-2002
YOUR 607 IN DETAIL

Maintenance position

This position enables the wiper
blades to be removed.
In the minute following switching off
of the ignition, any action on the stalk
positions the wipers in the centre of
the windscreen so that they may be
cleaned or replaced.
To park the wipers after this has
been done, switch on the ignition
and operate the stalk.

Windscreen and headlamp wash

Pull the windscreen wiper stalk
towards you.
The windscreen wash then the wind-
screen wipers operate for a fixed
period. The windscreen wash and
headlamp wash operate simultane-
ously for a few seconds, only if the
dipped beam or main beam head-
lamps are on.
been

Screenwash/headlamp wash low

When the minimum level of
the reservoir is reached, this
warning light comes on,
accompanied by an audible
signal and the message
'Screenwash low' on the multi-func-
tion display.
Next time you stop, fill the screen-
wash / headlamp wash reservoir.
If the reservoir is empty, the warning
light comes on when the ignition is
switched on, or every time the stalk
is operated, until the reservoir is
filled.
Do not cover the rain
sensor located on the
windscreen behind the
interior mirror.
When using an automatic
car wash, switch off the ignition or
check that the wiper stalk is not in
the automatic position.
In winter, it is advisable to wait
until the windscreen is completely
free of ice before operating the
automatic wipe
111