Memorising Seat And Mirror Positions; Memorising Using The Buttons; Recalling A Memorised Position; Engine Running - PEUGEOT 607 Manual

Memorising seat
and mirror positions
Four driving positions can be memo-
rised:
– two, using two remote control
keys (two users),
– two, using buttons M/1 and M/2.
Driving positions memorised by
the remote control key
When locking the doors, the remote
control key memorises the position
of the driver's seat and the exterior
mirrors.
When unlocking the doors, the dri-
ver's seat and the exterior mirrors
resume the position memorised by
the remote control key if this has
changed in the meantime.
Each remote control key can
memorise a specific setting.
15-07-2002
YOUR 607 IN DETAIL

Memorising using the buttons

To memorise:
Place the ignition key in the 'run-
ning' position (2nd notch),
Adjust your seat and mirrors,
Press button M, then button 1
(first driving position) or button 2
(second driving position) within
four seconds.
An audible signal confirms that a
position has been memorised.
Memorising a new position cancels
the previous one.

Recalling a memorised position

Engine off
Briefly press button 1 or 2 to recall
the corresponding
position. The end of the setting is
indicated by a bleep.
Note: after recalling a memorised
position five times in succession, the
function will be cancelled until the
engine is started.

Engine running

Keep button 1 or 2 pressed down
until the bleep indicates the end of
setting of the corresponding mem-
orised position.
Front and rear heated seats
controls
Press the switch. The tempera-
ture is regulated automatically.
Press it again to stop operation.
Note: the command to activate heat-
ing of the seat(s) remains in the
memory for two minutes after the
ignition is switched off.
memorised
95