Usb Peripherals; Updating The Ibm Cp20 Workstation Connection Device Firmware - IBM CP20 - Workstation Connection Device KVM Installation Instructions Manual

USB peripherals

If a keyboard, mouse, or other USB peripheral is not working, use the following
steps to troubleshoot the problem.
1. If the USB device has an on/off switch, turn the device off and then turn it back
2. Reseat the USB device.
3. Install the USB device into another USB port on the workstation connection
4. Configure the USB permissions on the workstation connection device to enable
5. Install the USB device on another system.

Updating the IBM CP20 Workstation Connection Device firmware

The following section gives information on how to update the firmware for the IBM
CP20 Workstation Connection Device.
Notes:
1. The workstation connection device and the compression card on the host
2. Changes are made periodically to the IBM Web site. The actual procedure might
Follow the steps below to update the firmware for your IBM CP20 Workstation
Connection Device:
1. Go to http://www.ibm.com/systems/support/.
2.
3. From the Product family menu, select CP20 Workstation Connection Device,
4. Download the firmware update to a management workstation such as a laptop.
16
IBM CP20 Workstation Connection Device: Installation Instructions
on.
device. If the USB device works in another USB port, the original USB port
might be failing.
support for all USB devices.
a. Open a Web browser from another system on the same subnet as the
workstation connection device.
b. Direct the Web browser to the IP address of the workstation connection
device.
c. Login to the workstation-connection-device interface.
d. Click Permissions, then USB.
e. Configure the first row of the USB device list:
1) To configure the "Entry Type" select Class.
2) To configure the "Device Class" select Any.
3) To configure the "Sub Class" select Any.
4) To configure the "Protocol" select Any.
5) Click Apply to use the new settings.
v If it does not work, replace the USB device.
v If the USB device works on another system, the workstation connection
device might need to be replaced.
system must be at the same firmware levels. For information on how to verify
the firmware level and updated the firmware of the compression card, see the
"Installation and User's Guide" for your host system.
vary slightly from what is described in this document.
Under Product support, click BladeCenter.
and click Go.