Garmin 010-11146-00 - GPS Receiver Remote Control Instructions Manual page 10

Using Patterns Assigned to the
EN
Programmable Buttons
After you assign patterns to the programmable
buttons, you can use them when the autopilot
is either engaged or disengaged. Using a
programmable button to begin a pattern will
automatically engage the autopilot.
To use a pattern assigned to a
programmable button:
1. On the GHC 10 Remote Control, press the
programmable button assigned to the pattern
you want to use.
2. The pattern appears on the remote control
screen. Press the left or right single or double
arrow button (
the direction and begin the pattern. If the
pattern does not require you to choose a
direction, press the programmable button again
to begin the pattern.
To use a button programmed with direction
control:
1. Bring the boat to a stop and disengage the
autopilot before changing throttle directions.
2. On the GHC 10 Remote Control, press the
programmable button assigned to the direction
control to toggle between forward and reverse.
EN–10
or ) to choose
Instructions