To Replace
the Water Filter
Open the grille panel at the top of the refrigerator. Remove the
replacement part of the filter unit by rotating the filter to the left
(counterclockwise)
90 ° to unlock it, then pull it down. Place a
bucket beneath the filter to catch dripping water.
Unpack the replacement filter from the box and peel off the
red protective cap. Place a date sticker on the new filter.
For example, if installing the new filter in April, put on an
"OCT 10" sticker (six months from the current date).
Place the top of the replacement filter up into the fixed part
of the unit, rotate it to the right (clockwise) 90 °, and align
the indicator arrow with the lock icon to lock the filter.
Close the grille panel on the top of the refrigerator, place
a glass against the dispenser cradle, and push the Water
pad to check for water flow. Run water for about 2 minutes
to clear the system.
Reset the indicator light by pressing the Filter pad
for 3 seconds until the light turns off.
Always consult the Use & Care Guide for more operating information.
_Lock
12