Using The Water And Ice Dispenser - Kenmore 4048 - Pro 29.5 Cu. Ft Quick Reference Manual

Using the Water and ice Dispenser
After installation, to flush out impurities in the water line
and to avoid a plastic smell or taste, throw away the first
six glassfuls of water and the first full bucket of ice.
Select the Water button for water, the Cubed button
for cubed ice, or the Crushed button for crushed ice and
press a glass gently against the middle of the dispenser
pad. Raise the glass closer to the chute opening to avoid
water splashing or ice bouncing out of the glass.
............ ][ . ...........
The first glass of water dispensed may be warmer than those following.
This is normal.
To activate the icemaker, turn the icemaker switch to ON (LED lamp red), then
lift the icemaker feeler arm three times. The icemaker motor will start once the
icemaker element is fully energized.
If no ice appears when one of the ice buttons is pressed, check the dispenser
for blockage. Also make sure the ice chute cover has been removed before use.
Also remember that it takes at least 12 hours after installation or depletion of the
ice supply to make a new batch of ice.
CAUTION:
DO NOT place your hands into the ice discharge
opening. Personal injurycould result.
Always consult the Use & Care Guide for more operating information,