Controls And Connectors - AOC LM727 Manual

CONTROLS AND CONNECTORS

SIGNAL CABLE
Connecting the Signal Cable: the LCD monitor comes with a built-in signal
cable. Plug the signal cable's 15-pin connector into the computer's VGA port and
tighten the two screws on the cable connector.
Connecting the Power Cord: Plug the AC-power cord into the External Adapter.
Then plug the DC-jack power cable into DC-IN Inlet.
Caution: If the AC outlet is not grounded (with three holes), install the proper
grounding adapter (not supplied).
1. Signal Cable
3. AC Power Cord
Figure 1 Connecting Cables
2. DC-Jack Power Cable
4. External Adapter
5