Controls And Connectors - AOC 2212PH User Manual

CONTROLS AND CONNECTORS

SIGNAL CABLE
Connecting the Signal Cable: Plug the Signal Cable one end to LCD
monitor's "DSUB-Input" socket, the other end to the computer's VGA port and
tighten the two screws on the cable connector.
Connecting the Power Cord: Plug the AC-power cord into the External
Adapter. Then plug the DC-jack power cable into DC-IN Inlet.
Connecting the DVI Cable: Connect one end of the 24-pin DVI cable to the
back of the monitor and connect the other end to the computer's DVI port.
Caution: If the AC outlet is not grounded (with three holes), install the proper
grounding adapter (not supplied).
Figure 2
1. Power input socket
2 HDMI input socket
3. DVI input socket
4. D-SUB input socket
5. COMPONENT
6. PC AUDIO IN
Connecting Cables
6