Visonic NEXT PG2 Installation Instructions page 2

3. ENROLLMENT
Refer to the PowerMaster-10 Installer Guide for the device enrollment procedure.
4. MODIFY DEVICE SETTINGS
This section describes how to configure the parameters of the PIR detector from the PowerMaster-10 control panel
To Modify the PIR Detector Device Settings
Refer to the PowerMaster-10 Installer Guide and perform the procedure for Adding A Wireless Device (section 4.5.2), or, Modifying a
Device (section 4.5.5). Then continue below to modify the device settings.
DEV SETTINGS
1.
Alarm LED
2.
LED ON
or
3.
4.
Alarm LED
5.
Event Counter
6.
LED Sensitive
or
7.
8.
Event Counter
9.
DISARM Activity
10.
NOT Active
11. or
12.
DISARM Activity
5. LOCAL DIAGNOSTICS TEST
A. Separate the base from the cover (see Fig. 5).
B. Put back the cover to return the tamper switch to its normal
(undisturbed) position, and then secure the front cover to the
base with the case closure screw.
C. Walk-test the coverage area - see Fig. 2. Walk across the far
end of coverage pattern in both directions, The red LED lights
each time your motion is detected followed by 3 LED blinks.
The following table indicates received signal strength
indication.
2
Here you determine whether or not the alarm LED indication will be activated.
Select between "LED ON" and "LED OFF".
Here you determine whether an alarm will be activated upon continued motion (low
sensitivity) or upon a single alarm event (high sensitivity).
Select between "LOW sensitive" and "HIGH sensitive".
Here you set the activity time during disarm.
Select between "NOT Active", "YES – no delay", "YES + 5s delay", "YES + 15s
delay", "YES + 30s delay", "YES + 1m delay", "YES + 2m delay", "YES + 5m delay",
"YES + 10m delay", "YES + 20m delay" and "YES + 60m delay".
When exiting "
ZONES / DEVICES
devices that need to be updated, as follows: DEV UPDATING NNN.
For detailed instructions on Adding Devices, Deleting Devices, Replacing Devices and
Defining Defaults see the PowerMaster-10 Installer Guide.
" menu, the PowerMaster-10 system displays the number of
LED response
Green LED blinks
Orange LED blinks
Red LED blinks
No blinks
Reception
Strong
Good
Poor
No communication
D-302413