Advertisement
Quick Links
780 mm
720 mm
230g
Kit Contents:
* fuselage
* wings
* horizontal stabilizer
Accessory Pack Contents:
* carbon diam. 1.5x50mm ... 2x
* brass pin clevises ... 8x
* heatshrink tube ... 5x
* bowden end ... 2x
* plastic arm ... 1x
* plywood parts
Horns etc.:
1. elevator horns
2. rudder horns
3. ailerons horns
You may also need:
* sharp x-acto knife
* philips screwdriver
*
tweezers
* little pliers
* CA glue medium + thin, CA kicker
* drill 1mm
* ruler
* pencil (marker)
* fine handsaw (Dremmel)
Li-pol
2206
8/4 - 8/6
3s 600-850
80-120w
* vertical stabilizer
* accessory pack
* pushrods set
3.
3.
1.
2.
V1.0
Advertisement
Related Manuals for RC Factory Nemesis
Summarization of Contents
Wing Preparation and Servo Installation
Wing Measurement and Cutting
Measure and cut wing sections as per specifications for proper assembly.
Adhesive Application and Assembly Check
Apply CA glue for bonding and verify correct assembly alignment.
Servo Centering and Preparation
Center servos and prepare them for installation into the wing.
Wing Servo Mounting
Securely attach servos to the designated locations on the wing panels.
Aileron Control System Setup
Aileron Horn Attachment
Install aileron horns onto the control surfaces.
Pushrod Connection and Preparation
Connect and prepare the pushrods for the aileron control system.
Control Linkage and Horizontal Stabilizer Assembly
Pushrod Assembly and Adjustment
Assemble and adjust pushrods for smooth operation of control surfaces.
Horizontal Stabilizer Mounting
Attach the horizontal stabilizer to the main fuselage.
Fuselage Modification and Powertrain Installation
Fuselage Preparation and Wing Attachment
Modify fuselage and attach the main wing assembly.
Motor and ESC Installation
Install the motor and electronic speed controller.
Vertical Stabilizer and Control Linkage Finalization
Vertical Stabilizer Attachment
Secure the vertical stabilizer to the fuselage.
Control Linkage Verification
Perform final checks on pushrods and control horn connections.
Rudder Control System Installation
Rudder Pushrod Assembly and Connection
Assemble and connect the rudder pushrod to the servo.
Rudder Horn Installation
Attach the rudder horn to the rudder control surface.
Elevator Pushrod Routing and Adjustment
Elevator Pushrod Routing
Route elevator pushrods through the fuselage for proper movement.
Final Linkage Connections
Make final connections for all control linkages.
Final Assembly and Wiring Management
Wing and Fuselage Integration
Attach wings to the fuselage and manage internal wiring.
Securing Internal Components
Use adhesive to secure internal components and wiring.
Electronics Installation and Pre-Flight Checks
Receiver Installation and Wiring
Install the receiver and organize all electronic wiring.
Propeller and Battery Setup
Install the propeller and prepare the battery for operation.
Final Assembly and Weight Check
Component Securing and Final Assembly
Secure remaining components and complete final assembly steps.
Weight and Balance Check
Check the model's total weight and center of gravity.
Need help?
Do you have a question about the Nemesis and is the answer not in the manual?
Questions and answers