Table of Contents
Advertisement
English
Insert the vent cover into the slot on the front of the range hood.
7
8. Fasten the vent cover with 2 screws supplied.
9. Remove appropriate Duct Knockout(s) from top or back of hood.
TOP RECTANGULAR DUCT KNOCKOUT
(Remove for 3¼" x 10"Vertical & for 7"Round Discharge)
NOTE: To accommodate off-center ductwork, the Damper/Duct
Connector can be installed up to 1-inch on either side of hood
center or the 7" Round Duct Plate can be installed up to ½" on
either side of hood center. In extreme off-center installations, one
end of the duct connector may need to be trimmed to clear the
electrical cable clamp.
7
(2) #8 Screws
BACK RECTANGULAR DUCT KNOCKOUT
(Remove for 3 1/4" x 10" Horizontal Discharge)
SEMI-CIRCULAR DUCT KNOCKOUT
(Remove for 7"Round Discharge)
Advertisement
Table of Contents
