Table of Contents
Advertisement
8.2 Engineer simple
To try out the algorithm, route a sound signal to the Engineer in the routing screen. Make
sure that the routed signal enters the algorithm at a minimum level of at least -30dBU. Then
click the picture of the sound engineer to open the engineer simple control window.
This windows shows you the input and output levels and gives you a basic feel of what's
going on in the algorithm: The three compasses on the right side of the window show the
amount of gain boosted or cut from the input signal, for the overall level as well as
specifically for the high and low tones.
The three knobs on the left side of this screen give you the opportunity to give a user offset
to the sound made by the engineer, so you can decide that you like the setting but you
would like to have a bit more bass or treble. You can consider these knobs a the 'User
Control' knobs, because the algorithm keeps the sound consistent, here the user can
determine that overall the sound needs some more bass or treble.
All material © 2007. Martin Audio Ltd. Subject to change without notice.
24
Advertisement
Table of Contents
