Table of Contents
Advertisement
5.3 Initializing communication
Once you've chosen in which way you want to synchronize, you'll be presented with the
communications dialog:
All available RS232 ports will be shown here, in this examples port 1, 2 and 4. Note the
check box in the bottom-left corner. Selecting this will prevent this dialog box from showing
up in the future, and set the communications port you select as the default. Make sure your
Engineer is connected to the port you select and hit "Connect" to start the synchronization.
During the synchronization process a progress bar will be shown. Please be patient while this
operation completes; this can take a few minutes in the case of many stored presets. Since
this is the first time though, only the factory defaults will be downloaded, which will be
relatively quick.
All material © 2007. Martin Audio Ltd. Subject to change without notice.
11
Advertisement
Table of Contents
